Main Page Sitemap

Loto safety procedure

loto safety procedure

Even after the energy source has been disconnected, in step 3 of the lockout safety process, and the machine has been locked out, in step 4, that doesnt entirely guarantee that theres no hazardous energy still stored within the machine or that its safe.
) that may be part of a particular machine or utility system.
Related Safety and Health Topics Workers' Rights Workers have the right to: Working conditions that do not pose a risk of serious harm.
Ensure that proper labeling is applied to all disconnect locations on specific equipment controlled by the department.
Lockout/Tagout Step 2: Shut Down, with planning complete, the actual process of powering down and locking out machines begins.Six Steps Of loto Safety Lockout/Tagout Procedures.4 (88.57) 7 votes, a lockout/tagout procedure should include the following six steps: Preparation, shutdown, isolation.Bolmen, Semiconductor Safety Handbook: Safety and Health in the Semiconductor Industry,William Andrew, 1998, isbn, page 298 5-components to lockout-tagout, ESC Services, best android mobile poker Inc., retrieved April 4, 2014 "Occupational Safety and Health Standards Subpart: R - Special Industries, Standard Number: 1910.269 Electric Power Generation, Transmission, and Distribution.Failure to control hazardous energy accounts for nearly 10 percent of the serious accidents in many industries.All Qualified persons must have documented training on this EI-loto Program.Citation needed To protect one or more circuit breakers in an electrical panel, a lockout-tagout device called the Panel Lockout can be used.Gases - poisonous, suffocating, and explosive, steam, gravity - falls from height, falling parts, or mechanisms that work with or against.The Contractor provides evidence of their EI-loto program to the University Project Supervisor / Manager upon request.3 While this may be true for the United States, it is not mandatory in Europe.

A person's lock and tag must only be removed by the individual who installed the lock and tag unless removal is accomplished under the direction of the employer.
Modern machinery can contain many hazards to workers from electrical, mechanical, pneumatic or hydraulic energy sources.
Read More About Lockout / Tagout.
Compliance edit If employees service or maintain machines where the unexpected startup, energization, or the release of stored energy could cause injury, the osha standard applies, unless an equivalent level of protection can be proven.
Contractors and Joint Projects The Contractor follows their own EI-loto program when working on University property / equipment.These locks and tags must also clearly identify the employee applying and using the device.Each worker applies their own padlock to the clamp.Extremely hot or cold surfaces, which may cause burns, liquids - gasoline or other fuels, chemicals, and water.The next step of the lockout/tagout procedure is to isolate the machine or equipment from any source of energy.How to Contact osha Under the Occupational Safety and Health Act of 1970, employers are responsible for providing safe and healthful workplaces for their employees.kinetic energy ( rotating flywheel, moving parts, rolling components, parked vehicles, etc.Tagout refers to applying a tag on the device as well.Workers must be trained in the purpose and function of the energy control program and have the knowledge and skills required for the safe application, usage and removal of the energy control devices.The circuit breakers remain in the off position while electrical work is done.For additional information, see osha's Workers page.4 A documented lockout/tagout policy may be requred by government regulations in some jurisdictions, for example in the United States for sites regulated by osha rules.No two keys or locks should ever be the same.For other devices such as ball or gate valves, plastic pieces which either fit against the pipe and prevent movement, or clamshell-style objects which completely surround the valve and prevent its manipulation are used.